When I installed the greddy boost cut controller in my supra my airbag light came on. Any info/advice.

Darren

Did you pull apart the dash for any reason with the key on, or neg. terminal still connected to the battery? Recheck your bcc wireing, and reset the ecu. To reset ecu go to fuse box in engine bay, and pull the ecu fuse for 20-30 sec. or so, and reinstall... Hopefully that will work.

97 Turbo, 6spd. BPU 462rwhp

yes pull it out...its not working because your gauge is reading 20 psi. hahaha. moderators dont delete this because i know him and ive giving him a hard time. hey man i live in laplata so im real close to you. where the hell are all the supras in so. md? where do you live in waldorf? email me at r1champs@aol.com

97TURBO, thanks for the tip.

Also, will someone sell CHAMPS387(Brad) a 97 RSP
6 speed so he will stop sweating my sack. HaHa

Darren

This is an article from mkiv.com this should help you fix the problem

How to turn off the airbag light

Problem: Disconnecting the connector behind the upper dash piece where the odometer is located while the ignition key is turned on will result in the airbag light staying on.

Here's how to turn it off :

Go under the hood and open the diagnostic cap located on the passenger-side near the firewall (see photo). Look for AB & TC. Make two plugs with wire to fit into these connectors. With the ignition key turned to the ON position alternate the two wires to the negative terminal of the battery. They need to be done in a consistent rhythm, about one second apart. TC,AB,TC,AB,TC,AB... This needs to be done several times. If you can't get it to work, try adjusting the speed. It is helpful to have someone look at the airbag light while performing this to let you know when the light goes out/blink.