I'm new just acquired a 1994 6 speed TT and in the process of going BPU. Any good starting points to set the Profec B II at? Just put in Tanabe down pipe and straight back to HKS Super Dragger no cat....live in Arkansas so no inspections. Just need some advise on settings as good shops are hard to find.

im not too familiar with the profec but there is a thread on this same topic heres link: http://i-supra.com/eve/forums?a=tpc&s=154607117&f=7936011951&m=493103615

What psi are you wanting to run at?
I think you supra guys when going BPU run at what, 18psi?

Here's a guide:

set: 30%
gain: 0%
set_gain: 4psi less than your set psi *example: 18psi is your goal, your set_gain would be 14psi, ~1.00kpa

Don't try converting it to psi, I have heard a lot of problems with the boost limiter and warning when you do this.

Once you start with these settings, slowly increase the gain value by increments of 2.

and keep increasing til you reach your set boost value. I run a 3000GT VR4 but I use the same controller. Email me with any questions:

ttran@trentontechnology.com

Tony

1.20kpa Is near damn it to 17psi depending on mods. I got a manual boost gauge and at 1.20kpa on the boost controller it is 1.2bar on the boost gauge wich is very near 17psi.