i-supra.com    i-supra.com    www.i-supra.com  Hop To Forum Categories  Clutch, Driveline & Transmission Section    clutch stuck to the floor

Moderators: Figgie
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
Member
Posted
got in my 87 supra turbo the other day pushed the clutch pedal in and it stuck to the floor. checked my master cylinder in it was almost empty, so i looked under my dash and there was a leak by the clutch pedal. i got some fluid and filled my master cylinder then pumped the clutch pedal about 200 times and there were still air bubbles coming out and the pedal didn't come back up at all and it wasn't getting stiffer and nothing connected to the pedal feels loose. Need Help
 
Posts: 58 | Location: S.D. | Registered: May 01, 2006Reply With QuoteEdit or Delete MessageReport This Post
Member
Picture of Fryit
Posted Hide Post
you say you have a leak inside of your car under your dash? that is weird. it sounds like you have a slit or cracked line and pressure isnt being built up. Trace the line from the clutch cylinder to the transimission to make sure if there are any leaks. thats where i'd start anyways. I'll look at mine and see if i can come up with anything. good luck man!


1988 Supra Turbo Targa.
 
Posts: 47 | Location: Novi, MI | Registered: March 29, 2005Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
sounds like what i went thru. your clutch master cylinder might have a broken seal for the shaft inside the cylinder itself. i had it happen on my civic and so did my friend. they are rebuildable since its only a rubber o-ring. check that too while your at it, it might be it. good luck
 
Posts: 65 | Location: PA | Registered: April 06, 2006Reply With QuoteEdit or Delete MessageReport This Post
Member
Posted Hide Post
Its sounds to me like your master cylinder is leaking if you have spotted fluid running down the inside of the car. If you follow where it has been running down you will see the part of the master cylinder thats inserted through your firewall. There is a clevis pin that inserts through the clevis to hold it to your pedal. Remove the clip and slide the pin out. After that just disconnect the hardline in the engine bay and then back off the nuts from the studs and it should slide right out.
 
Posts: 57 | Location: ct | Registered: May 12, 2003Reply With QuoteEdit or Delete MessageReport This Post
Mid-level Member
Picture of billspreston01
Posted Hide Post
replace the master cylinder. It's not that expensive from toyota. Smile
 
Posts: 640 | Location: Ohio | Registered: October 22, 2004Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community  
 

i-supra.com    i-supra.com    www.i-supra.com  Hop To Forum Categories  Clutch, Driveline & Transmission Section    clutch stuck to the floor

© YourCopy 2001